Which 32bit board/firmware to go for? (sorry!) (8 replies)

Hello everyone :) My apologies for asking this probably very common question.

So I'm building a slight variation on the standard D-Bot by Spauda01 and I'm having a hard time choosing which 32bit board and accompanying FW/screen.
Googling for existing discussions has just resulted in me flipping back and forth between things - mainly RADDS/Due and Duet and now I'm stuck :o, but I'm open to options.

I'll be running the following main hardware if it helps:

Full 24v system
0.9° Steppers (Wantai 42BYGHM810)
'Pancake' stepper (17HS08-1004S) on a Titan DD setup
300w/~12.5A 300x300mm silicone heater
24v E3D V6

- Kind of had my eye on 128 stepper drivers, though I don't see myself actually going that far. It's more about having the option to reduce operating noise and any resolution increase is a bonus. Silencio drivers are a bit pricey for tastes fwiw.
- Was also looking at PanelDue, though I'd be ok with any screen/FW combo that does the job in terms of info and at least basic control.
- Not bothered about wifi/ethernet capability.

I'm not a technophobe, but this will be my first 3D printer and I'd ideally like to be able to work with FW that isn't a total nightmare to get my head around.

Thanks in advance for any advice you can offer, and do let me know if there's any more info that would be helpful.

Oh, and I'm based in the UK if that helps in terms of availability of certain things.

EDIT

I think I've decided on the Duet, so never mind.
Of course, any opinion is still welcome :)