Found on youtube a german guy that is building a corexy printer with a belt path different of the usual ones, check the video:
[www.youtube.com]
This setup allow to simplify a lot the pulley locations and both belt are in the same plane.
I really liked this setup and i was planning to use it, but i not sure if the twist of the belt can give or not troubles.
I would like to listen yours opinions about this setup..
[www.youtube.com]
This setup allow to simplify a lot the pulley locations and both belt are in the same plane.
I really liked this setup and i was planning to use it, but i not sure if the twist of the belt can give or not troubles.
I would like to listen yours opinions about this setup..