I ask here cause its problably where must of those idler/pulley are used.
Im looking at robotdigg 9mm idler smooth (brass one) and toothed link and cannot find the right dimension. They said they use 695 bearing (13mm OD) in them, its impossible for the toothed (20 tooth = 12.10mm) so this must be for the smooth one but they have very limited dimension info.
Anyone have them and can comfirm the OD of the smooth one where the belt sit and the height of both toothed and smooth?
I write a email to them asking the right dimension but since they know for not answering must of the time I try to double my chance asking here too just in case.
I guess im force to take a break into designing the printer then, without those info its kinda hard to plan the alignment or bracket dimension to fit them.
Im looking at robotdigg 9mm idler smooth (brass one) and toothed link and cannot find the right dimension. They said they use 695 bearing (13mm OD) in them, its impossible for the toothed (20 tooth = 12.10mm) so this must be for the smooth one but they have very limited dimension info.
Anyone have them and can comfirm the OD of the smooth one where the belt sit and the height of both toothed and smooth?
I write a email to them asking the right dimension but since they know for not answering must of the time I try to double my chance asking here too just in case.
I guess im force to take a break into designing the printer then, without those info its kinda hard to plan the alignment or bracket dimension to fit them.