[attachment 88750 1-9c.jpg][attachment 88751 1-9b.jpg][attachment 88752 1-9a.jpg]Hi.
Seeked out this forum to help with my first 3d printer design.
Hlidskjalf is a dual CoreXY 3d printer with CNC capabilities: [www.thingiverse.com]
The print heads are twin Toranado extruders: [www.thingiverse.com]
Some info:
24VDC 1000W PSU
.5 N-m steppers belted 2:1
MGN12 linear guides with H blocks
1605 anti-backlash ball screws
RADDSv1.5, RAPS128, Arduino Due with 7" Panel Due
Soon to begin wiring and testing with a single head using Repetier.
What I need help with is software implementing dual head support, and later linking X-carraiges for full out CNC.
Probably a good month away from powering up, so thought now is a good time to start fishing these waters.
Will barter for code.
Tom West
AKA Prot0typ1cal
Seeked out this forum to help with my first 3d printer design.
Hlidskjalf is a dual CoreXY 3d printer with CNC capabilities: [www.thingiverse.com]
The print heads are twin Toranado extruders: [www.thingiverse.com]
Some info:
24VDC 1000W PSU
.5 N-m steppers belted 2:1
MGN12 linear guides with H blocks
1605 anti-backlash ball screws
RADDSv1.5, RAPS128, Arduino Due with 7" Panel Due
Soon to begin wiring and testing with a single head using Repetier.
What I need help with is software implementing dual head support, and later linking X-carraiges for full out CNC.
Probably a good month away from powering up, so thought now is a good time to start fishing these waters.
Will barter for code.
Tom West
AKA Prot0typ1cal