Hello guys, I have two issues with an H-BOT printer, here I attached a picture with the two issue what I think it describes much better than explain it..
1.- I setted the H-bot printer as picture, motor 1 and 2 at back side. Y-min endstop at back left, & X-min endstop at left side.
It seems the X-asis print in the right direction but inverted at Y-axis?? How could I solve this issue in a H-bot printer?
2.- The printer is a large version and z side is around 400mm. I tested to print a tall cube and the result is till 200mm or so print correct and then it shift on X-axis a little (around 1/3mm in around 100mm tall.
I guess it's a Z-axis calibration?
[attachment 89273 issuescopia.jpg]
I appreciate all your replies and help!!
Regards
1.- I setted the H-bot printer as picture, motor 1 and 2 at back side. Y-min endstop at back left, & X-min endstop at left side.
It seems the X-asis print in the right direction but inverted at Y-axis?? How could I solve this issue in a H-bot printer?
2.- The printer is a large version and z side is around 400mm. I tested to print a tall cube and the result is till 200mm or so print correct and then it shift on X-axis a little (around 1/3mm in around 100mm tall.
I guess it's a Z-axis calibration?
[attachment 89273 issuescopia.jpg]
I appreciate all your replies and help!!
Regards