Hi all,
Having owned an I3 clone for the last 2 years, I am about to embark on a DBOT build. The main reason I am swapping platforms is the COREXY looks to be more stable and will enable me to use a more substantial bed that I could on the I3.
I have am already printing the parts as we speak but I looking at the following spec..
300x200 D-bot with 4 Z gantries instead of 2 and some aluminium parts instead of printed
Duet Wifi running @ 24V
0.9 steppers on Z and XY - not sure about extruder as I'm not sure if I should go Bowden or Titan
Closed belt between 2 Z steppers to keep position when the machine is off.
6mm MIC-6 aluminium bed with 300w 24v silicone heater
600w 24v 25A PSU.
I am hopefully also going to enclose it aswell with Perspex/acrylic in the slots but not reasearched that yet!
Most of the parts are on order as I type so I will update the thread with photos/question etc ASAP!
Thanks,
Shaun
Having owned an I3 clone for the last 2 years, I am about to embark on a DBOT build. The main reason I am swapping platforms is the COREXY looks to be more stable and will enable me to use a more substantial bed that I could on the I3.
I have am already printing the parts as we speak but I looking at the following spec..
300x200 D-bot with 4 Z gantries instead of 2 and some aluminium parts instead of printed
Duet Wifi running @ 24V
0.9 steppers on Z and XY - not sure about extruder as I'm not sure if I should go Bowden or Titan
Closed belt between 2 Z steppers to keep position when the machine is off.
6mm MIC-6 aluminium bed with 300w 24v silicone heater
600w 24v 25A PSU.
I am hopefully also going to enclose it aswell with Perspex/acrylic in the slots but not reasearched that yet!
Most of the parts are on order as I type so I will update the thread with photos/question etc ASAP!
Thanks,
Shaun