Im having some headaches trying to get to the bottom of weird dimensional problems.
My machine is a hypercube evolution and was running ok a while back so i know belt paths etc are all ok, frame is solid.
Running marlin firmware, slicing with cura and slic3r
Dimmensions from picture
x bottom 101.15
x top 100.00
y left 100.47
y right 101.13
diagonals are even at 142.55
I have adjusted belt tension in every way with only very minor effect.
rotated 45 degrees which resulted in acceptable sizes 100+-0.1 but was skewed.
I checked a print i did a few months ago and its all square !
I just cant see where its coming from, Any ideas ?
My machine is a hypercube evolution and was running ok a while back so i know belt paths etc are all ok, frame is solid.
Running marlin firmware, slicing with cura and slic3r
Dimmensions from picture
x bottom 101.15
x top 100.00
y left 100.47
y right 101.13
diagonals are even at 142.55
I have adjusted belt tension in every way with only very minor effect.
rotated 45 degrees which resulted in acceptable sizes 100+-0.1 but was skewed.
I checked a print i did a few months ago and its all square !
I just cant see where its coming from, Any ideas ?