Hi i have updated my slicr software and i tried to print multiple parts at once. Software was printing every part in same layer in old version. But the new version started to print every part individualy. After printing few parts the hotend and fan duct started to crash other parts and all axises forced.
After that i started printing again. The parts on the upper left corner and lower right corner started to show layer shift on x axis.
At the center of the bed there is no problem.
Has the belt tooth torn out?
After that i started printing again. The parts on the upper left corner and lower right corner started to show layer shift on x axis.
At the center of the bed there is no problem.
Has the belt tooth torn out?