Can someone explain this? Picture is of 1st layer (0.25) being printed. It started at the right front corner and went to the rear right corner. Then came back to finish the left side printing to the left. Printing to the right is rough, printing to the left is VERY smooth. 2nd layer (0.15) is printing smooth going over rough 1st layer to the right, and not so smooth printing to the left. It appears like the motor that is stepping lines going to the left (moving the head towards it) it not stepping the same distance and causing the lines to be too close together. But there is no gap at the end so the slicer seems to be in control. If it were a mechanical issue, I would expect there to be a gap with all those lines being too close.
CoreXY, Slic3r, 0.4 nozzle, 20mm/sec 1st layer, 50mm/sec 2+.
[attachment 106073 Picture243-25.jpg]
CoreXY, Slic3r, 0.4 nozzle, 20mm/sec 1st layer, 50mm/sec 2+.
[attachment 106073 Picture243-25.jpg]