hi,
I having some problems printing some more complex objects. The problem is the print is not fluid and was some micro stops, was result the print was tiny blob and the walls are not uniform.
I have read this problem is common with deltas printer that use 8 bit board with lcd, because the lack of power of the ramps.
My configuration: last version of repetier, ramps, mega, 1/16 steppers and full graphic lcd, raspberry with octoprint connected by usb.
Is there a way to print without this issue and with the lcd?
I not sure what is the best move to solve this...
Maybe replacing the full graphic lcd to an 4x20 lines?
replace the ramps to an 32 bit board? something like ramps-fd or radds?
Try to optimize the repetier firmware?
use 1/8 steppers in the extruder and z?
If you have an corexy printer I would to know what configuration you have?
I having some problems printing some more complex objects. The problem is the print is not fluid and was some micro stops, was result the print was tiny blob and the walls are not uniform.
I have read this problem is common with deltas printer that use 8 bit board with lcd, because the lack of power of the ramps.
My configuration: last version of repetier, ramps, mega, 1/16 steppers and full graphic lcd, raspberry with octoprint connected by usb.
Is there a way to print without this issue and with the lcd?
I not sure what is the best move to solve this...
Maybe replacing the full graphic lcd to an 4x20 lines?
replace the ramps to an 32 bit board? something like ramps-fd or radds?
Try to optimize the repetier firmware?
use 1/8 steppers in the extruder and z?
If you have an corexy printer I would to know what configuration you have?