I am building a corexy printer that contains 2020 aluminium extrusion frame. Now that all the mechanical stuff is finished I have to start wiring electronics. It seems that almost everyone puts Arduino/Ramps board and a LCD at the bottom of the printer under the printbed. I was trying to fallow this approach but it is giving me an headache as the wires are on the short side and it seems that doing a maintenace would be frustrating.
Why not put boards on the top of the printer? Most of the electronics are up there (except for Z motors) so it makes sense for me do it this way.
Why not put boards on the top of the printer? Most of the electronics are up there (except for Z motors) so it makes sense for me do it this way.