I wanted to mount a rhino worm gear to a 20x20 profile and found that the shaft was a bit crooked. It is not parallel to the profile. See the picture, the shaft is off more than 1mm on one side.
The Rhino box should have all sides perpendicular and the shaft does not throw at all when turning, there is no play.
It seems the shaft mount (yellow wheel) may be bent slightly. Is this ever possible or I'm wrong?
Is there any way to fix this? There are some screws, but I don't know if I can loosen them. I unscrewed the motor, but it wouldn't come out. I think the transmission worm was holding it in.
@the_digital_dentist: Still using the rhino on the z-axis, have you had any problems with it?
The Rhino box should have all sides perpendicular and the shaft does not throw at all when turning, there is no play.
It seems the shaft mount (yellow wheel) may be bent slightly. Is this ever possible or I'm wrong?
Is there any way to fix this? There are some screws, but I don't know if I can loosen them. I unscrewed the motor, but it wouldn't come out. I think the transmission worm was holding it in.
@the_digital_dentist: Still using the rhino on the z-axis, have you had any problems with it?
