Hi,
My coreXY is finally printing, but experiencing some shifting that makes the prints essentially unrecognizable. I've attached a picture of the first layer of what should be a calibration cube. It prints the perimeters more or less reasonably (although there is a gap between the top and left lines), but the infill looks totally bizarre as it's shifted away from the square. Any idea what might be causing this? I've successfully managed to print something similar before, but after a bunch of tweaking this is now the result.
Thanks in advance.
My coreXY is finally printing, but experiencing some shifting that makes the prints essentially unrecognizable. I've attached a picture of the first layer of what should be a calibration cube. It prints the perimeters more or less reasonably (although there is a gap between the top and left lines), but the infill looks totally bizarre as it's shifted away from the square. Any idea what might be causing this? I've successfully managed to print something similar before, but after a bunch of tweaking this is now the result.
Thanks in advance.