I've built a CoreXY printer with the following equipment:
RUMBA controller
Stepper drivers are DRV 8825's (all 6)
32 micro bit stepping
Diamond hot end
(Red, Green, Blue filaments)
Dual Z stepper motors
Full RepRap graphics display
Heated bed
I've been trying to get Repetier firmware to work with this setup and have been unsuccessful. If anyone has the same setup would you please consider sharing your configuration.h, pins.h and any other files you may have modified.
thank you for your consideration
RUMBA controller
Stepper drivers are DRV 8825's (all 6)
32 micro bit stepping
Diamond hot end
(Red, Green, Blue filaments)
Dual Z stepper motors
Full RepRap graphics display
Heated bed
I've been trying to get Repetier firmware to work with this setup and have been unsuccessful. If anyone has the same setup would you please consider sharing your configuration.h, pins.h and any other files you may have modified.
thank you for your consideration