I've already build a version of a hypercube original from tech2c with a 220x220 bed and it's perform great. Now i'm looking for a designer to build a coreXY with 200x300 or a 270x240 (ultrabase bed). And I know that is not a great design to use two dual Z motor to lift the bed, in order avoids the need to re-synchronise the leadscrews after a power cycle or some other syncronise problems. I know its a popular design cbots and hypercube evolution are doing that alot.
So my ideia is keep the design as simple as possible, with one leadscrew pushed by a motor to avoid the belt syncronize system or the dual motor system.
Did you think a hypercube/hypercube evolution with one motor and 2 linear roods with 12mm perform well with a bed of 200x300. It maintain the same Y dimensions i'm only extend the X length.
So my ideia is keep the design as simple as possible, with one leadscrew pushed by a motor to avoid the belt syncronize system or the dual motor system.
Did you think a hypercube/hypercube evolution with one motor and 2 linear roods with 12mm perform well with a bed of 200x300. It maintain the same Y dimensions i'm only extend the X length.