[youtu.be]
I recently purchased a Tronxy X5SA-500-Pro printer and have been having troubles. Even after resetting to factory settings and leveling out the z-axis motors, the auto-leveling still says there are large discrepancies in the bed. These discrepancies are so large that moving the screws has little impact--the method that tronxy suggests to level the plate (fixing one large number in leveling results in another large number elsewhere on the plate, screws being completely unscrewed, etc.).
I have a feeling this problem arises from the printing bed itself not being true. This is indeed the case, but I'm wondering if it would cause this large an issue: the plate is warped inward like a bowl, with the highest edge 2mm above the center.
Let me know if you have any ideas or fixes!
Thanks,
James
I recently purchased a Tronxy X5SA-500-Pro printer and have been having troubles. Even after resetting to factory settings and leveling out the z-axis motors, the auto-leveling still says there are large discrepancies in the bed. These discrepancies are so large that moving the screws has little impact--the method that tronxy suggests to level the plate (fixing one large number in leveling results in another large number elsewhere on the plate, screws being completely unscrewed, etc.).
I have a feeling this problem arises from the printing bed itself not being true. This is indeed the case, but I'm wondering if it would cause this large an issue: the plate is warped inward like a bowl, with the highest edge 2mm above the center.
Let me know if you have any ideas or fixes!
Thanks,
James